SuSE expects a default router to be supplied by the DHCP server, otherwise it assumes that the interface is not functional.Įnsure thst you have specified a default router in the nf file. You'll find instructions on how to create it in boot/README on CD1 or DVD. When booting a blade during a SuSE installation, the blade does not boot automatically and you are prompted to perform an interactive installation: Prompted to Insert Module Disks During PXE Boot (SUSE only) This avoids a known interaction issue between the i82557/i82558 10/100 Ethernet hardware and the Broadcom 5704. Note - The eth instance may be different depending on your hardware setup. The PXE server may be using the eepro100 driver.ġ.Ĝheck if the PXE server is using the eepro100 driver by examining the /etc/nf file for a line equivalent to: Since the TFTP protocol is so simple, there are no really obvious advantages to choosing one TFTP server over another. Fails with an error message indicating that the signal 11 was received. A Twisted-based TFTP implementation that implements: RFC1350 (base TFTP specification) support. Another popular TFTP server for Linux is tftpd-hpa.Hangs after the OS requests an IP address from the PXE server. When PXE installing a blade, the installer does one of the following: Installer Hangs or Fails During PXE Boot Installation To unmount all file systems and enable the blade to reboot correctly, ensure that you press Enter at the final OK prompt during the PXE boot installation. When booting the blade from the disk for the first time, the blade runs fsck to fix filesystems. The BIOS is configured to boot from the network by default.Īt the SC prompt, use the bootmode reset_nvram sn command to reset the BIOS to boot from the disk by default. You must re-install the blade.Īfter successfully completing a PXE boot installation, the blade continues to boot from the network instead of the disk. This problem may occur if the blade is removed or powered off during installation. The PXE boot installation did not complete. GRUB version 0.92 (634K lower / 522176K upper memory) Root Password Message After Installing the Linux Kernelĭuring a PXE boot installation, the following message appears after loading the Linux kernel: An exact match is necessary to ensure that module versioning does not cause the 5704 network driver ( suntg3) to fail to load. This occurs if the linux distribution installed on the PXE server does not exactly match the linux distribution against which the supplemental CD (supplied with the Linux blade) was built. If the NFS services are working normally and can be used from other machines on the network, it is likely that the PXE server has provided the wrong kernel to the blade. See the Sun Fire B1600 Chassis Administration Guide for information on installing the SSC. If you have only one switch and system controller (SSC) installed on the chassis, ensure that the SSC is installed in position 0. This problem may also occur if the blade is not correctly connected to the PXE server. If this path is not in the output, check your NFS setup and configuration. # showmount -e Export list for PXE-server : /tftp (everyone)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |